Manufacturer of cutback bitumen MC 30

bitumen

General description of bitumen MC 30

Bitumen MC30 is dissolved of bitumen in solvents of kerosene. In many countries kerosene and other volatile petroleum derived products are added as a cutter or cutback agent to bitumen to reduce (or cutback) the viscosity of the bitumen. The mixture obtained may be called cutback bitumen or liquid bitumen MC30.

The reduction in viscosity of the bitumen aids the construction of seal coats in road pavements as the softened mixture wets the chips more easily so the cutback agent evaporates from the seal coat, then cutback agent becoming a negligible component of the seal coat a few months after application. If significant amounts of the cutback agent remain in the seal coat an unwanted long term softening effect may result.

Uses of liquified bitumen MC30

Cutback agents are used to lower the viscosity of bitumen when it is applied as a primer to the surface of a road pavement aggregate base course or substrate. Kerosene is used as a bitumen cutback agent at different concentrations according to local conditions and requirements.

The liquified bitumen is ideal for prime coat and cold applied because of easy uses and no need to thinning and heating.Liquid bitumen MC30 consist of initial incorporation of asphalt into the surface of non-asphalt based course preparatory to any superimposed treatment of construction.

The cutback bitumen MC30 applying to waterproofing of surfaces, plug capillary voids, coat and bond loose mineral particles.

Packing of liquid bitumen MC 30

Packing of liquid bitumen MC30 is in new thick steel drum on pallet to prevent any leak inside of container also bulk in bitutainer and tanker.

Guaranty/warranty of cutback MC30

ATDM guaranty the quality of liquid MC30 with arrangement of international inspector to check quality and quantity of the bitumen on each shipment during the loading to vessel and controlling the production by QC team via batch test report before shipping. ATDM guaranty the quality to meet with ASTM/EN 15322:2009

Analysis and specification of bitumen MC30

PropertiesMinMaxTest Method
 Kinemalic 1 viscosity at 60°C, eSt3060ASTM D2170
 Flash Point (Tag Open-Cup),°C38ASTM D1310
 Distillate test 2 :   
 Distillate, percent by Volume of total 360°C
 To 190°C15ASTM D402
 To 225°C2060ASTM D402
 To 260°C5090ASTM D402
 To 316°C8090ASTM D402
 Residue from distillation to 360°C:
 Test on residue from distillation Penetration at
25°C,100g, 5 sec.
50 
 Ductility 3 at 25°C, cm120250ASTM D402 / ASTM D113
 Solubility in trichloroethylene, percent mass100ASTM D402 / ASTM D2024
 Water, percent volume0.2ASTM D95

 

Specification of Bitumen Mc30

 

MSDS of Bitumen MC30

MSDS of Bitumen MC30

Hello how can i help you?